The Abrasive Machining Center (AMC) will produce complex parts out of virtually any material. It is ideal for producing high-volume, short run, or prototype parts. The AMC is designed for operation in the abrasivejet environment and provides ease of operation, minimal maintenance, high reliability, and increased productivity and profitability. AMC table size: 30" x 48."

AquaVision Di Motion Controller
The AMC is controlled by the PC-based AquaVision Di motion controller. Featuring a 40GB hard drive, 512MB memory and two USB ports, The AquaVision Di is the most advanced waterjet motion controller in the industry. From the customized Visual Basic front end, the user is guided through the process from job set-up to production. Single parts, part arrays, mirroring, scaling, rotation, and plate alignment are right at your fingertips. It is fully networkable, allowing part programs to be generated offline and easily transferred to the system's hard drive for production

Construction
The AMC frame is a steel structure designed for rigidity and accuracy. This system, which uses brushes, labyrinth passages, lip seals, and high-volume, low-pressure filtered air to protect critical motion components, provides significantly longer service life compared to conventional bellow-type arrangements. The AMC isolates the catcher tank from the motion system so the energy from the cutting stream does not disrupt the mechanics of the motion system.

Finish
High solids, polyurethane

Standard Features
Pass through design allows system to be used as cutoff for long material
Lip seals over motion mechanicals eliminate troublesome bellows
Heavy duty welded steel construction for rigidity and accuracy
6" manual Z-axis
+/-0.005" positioning tolerance
+/-0.001" bi-directional repeatability tolerance
300 Inches Per Minute Contouring and Rapid Positioning
PC-based waterjet controller